夹具订制
AGG可在机械手和模具间提供精i准的中心。
注塑模具内金属嵌件安放时尤其要注意这一点。
夹具AGG...B 安装在EOAT上，钢管 AGG...C 安装在模具上。
一旦机械手向模具靠近，夹具在压力的作用下逐步向钢管靠近，
并与之接触。
AGG21-B 和 AGG30-B 采用的是双动作安全弹簧，确保在压缩空
气 (NC)缺失时设备的正常运行。
AGG19-B 采用的是单动作复位弹簧(NO)。
Gripper for engagement
The AGG is used to provide a precise centering between the robot
and the mould.
This necessary when metal inserts must be p1aced in the
mould, before the p1astic injection.
The gripper AGG…-B is fitted on the EOAT, while the steel bushing
AGG…-C is fitted on the mould.
Once the robot has approached the mould, the gripper is
pressurized, thus it closes and engages the bushing.
AGG21-B and AGG30-B are double-acting with a safety spring to
keep the gripper engaged even without compressed air (NC).
AGG19-B is single-acting with reset spring (NO).
SB系列传感器接线盒
• 用于EOAT上传感器接线。• 可以转换PNP和NPN信号。• Is/Os可以是拉电流（PNP）、灌电流（NPN）或干触点。• 可以串联多个盒子来控制更多传感器。• 输入信号重复LED，便于排除故障（不适用于SB15）。• 提供应变消除装置和固定至型材的套件。
Connection boxes for series SB sensors• Used for sensor wiring on EOATs.• PNP and NPN signals can be converted.• Is/Os can be current sourcing (PNP), sinking (NPN) or dry contact
Several boxes can be connected in series to control more sensors
Input signal repetition LED for easy troubleshooting (not for SB15).
Provided with strain reliefs and kit for fastening to profles.
带端子板的传感器盒
IP66聚苯i乙烯传感器盒。• 可定制的电缆进线和出线，配有标准电缆密封套。• 2个螺钉端子，可直接连接15个输入/输出 。• 随附铝挤压型材直接固定螺钉。• 每个连接线路的zui大开关电流达1A。
IP66 polystyrene sensor box.• Customizable cable input and output with standard cable gland
2 screw terminals with direct connection of 15 inputs/outputs. • Supplied complete with direct fxing screws for aluminum extruded profles.
Maximum switching current up to 1A for each connection line.
以上信息由专业从事手动旋转装置的吉玛泰克于2025/8/1 14:24:05发布
转载请注明来源：http://jining.mf1288.com/jmtkzdh-2879812082.html
